Installation manual of direct buried battery

Installation manual of direct buried batteryThanks for choosing zhongv's products. Zhongv's battery waterproof direct burial box is made of high-quality PVC and PPS board, with the characteristics of high strength, excellent anti-corrosion performance, strong appearance luster and elegant appearance. The thermal insulation layer is made of polyurethane foam, which has good thermal insulation performance and poor water absorption. Due to the different requirements of specific engineering projects, the product structure, appearance and accessories will be adjusted. Please refer to the actual product.

I. product description

1.1 box structure description

1. Box (PVC)

2. Base (PVC)

3. Sealing joint (nylon)

4. Connecting pipe (PP)

5. Tie hoop (stainless steel)

6. Conductor pipe (tendon)

7. Fastening screw (Galvanized)

1.2 description of auxiliary parts

II. Installation process

2.1 before the installation of storage battery, the foundation pit shall be excavated. It is suggested that the size around the foundation pit shall be more than 40-50cm larger than that around the storage battery box to facilitate the installation of the storage battery box. The specific size can be adjusted according to the actual size of the storage battery box and the site construction conditions. The PVC wiring pipe with the diameter of 100mm is embedded in the riser foundation, and the arc joint is used in the middle of the wiring pipe.

2.2 install the base and place the base flat in the battery foundation pit (as shown below)

2.4 place the batteries and connect them to the base according to the design requirements, and connect the relevant cables (as shown in the figure below)

3. Cover the box, screw on the box, and tighten the screws or add sealing cement. (chart below)

4. Soil filling required for backfilling, installation completed
  报错